AFF 2-tons rivningsdomkraft modell 208 användarmanual

Viktig säkerhetsinformation

Read and understand all instructions and warnings in this manual before operating this service jack. Failure to follow these instructions may result in serious injury or property damage. Keep this manual for future reference.

• Always use jack stands: Never work under a vehicle supported only by a jack. Always use appropriately rated jack stands to support the vehicle after lifting.
• Do not exceed rated capacity: This jack has a maximum lifting capacity of 2 tons. Do not attempt to lift loads exceeding this limit.
• Use on a hard, level surface: Ensure the jack is placed on a firm, level surface capable of supporting the load. Avoid uneven or soft ground.
• Centrera lasten: Position the jack saddle directly under the vehicle's lifting point. An off-center load can cause instability.
• Hålla undan: Ensure all personnel are clear of the vehicle before and during lifting or lowering operations.
• Inspektera före varje användning: Check the jack for any signs of damage, leaks, or wear before each use. Do not use a damaged jack.
• Proposition 65 Varning: Denna produkt kan utsätta dig för kemikalier inklusive bly, som är känt för delstaten Kalifornien för att orsaka cancer och fosterskador eller andra reproduktionsskador. För mer information gå till www.P65Warnings.ca.gov.

Produkt överview

The AFF 2 Ton Wrecker Service Jack Model 208 is designed for efficient and reliable vehicle lifting. It combines robust construction with user-friendly features for both professional and home use.

Nyckelfunktioner

• Lightweight Anodized Aluminum Frame: Provides strength while reducing overall weight for easier portability.
• Double Pumper Technology: Features a twin hydraulic system for faster and more efficient lifting.
• Polished Plunger Pistons: Designed for a smooth surface, contributing to a longer seal life.
• Wiper Seals: Prevents dirt and contaminants from entering the hydraulic system, enhancing durability.
• Front Rollers and Padded Side Handles: Facilitate easy maneuverability and transport.

Komponenter

• Lyftarm: The primary component that raises the vehicle.
• Sadel: The contact point with the vehicle's lifting point.
• Hantera: Används för att pumpa domkraften och styra utlösningsventilen.
• Hjul/Länkhjul: Allow for easy positioning and movement of the jack.
• Hydraulisk enhet: Contains the fluid and pumping mechanism.

Installationsinstruktioner

Uppackning

1. Carefully remove the jack from its packaging.
2. Inspect the jack for any shipping damage. If damage is found, do not use and contact your supplier immediately.
3. Se till att alla komponenter som anges i förpackningen finns med.

Handtag Montering

1. Insert the lower handle section into the handle socket on the jack.
2. Rikta in hålen och säkra handtaget med den medföljande stiftet eller bulten, se till att det sitter ordentligt fast och är låst.
3. Fäst den övre handtagsdelen på den nedre delen, om tillämpligt, och säkra den.

Initial Bleeding Procedure

Before first use, it is recommended to bleed any air from the hydraulic system to ensure proper operation.

1. Vrid utlösningsventilen moturs för att öppna den helt.
2. Pump the handle vigorously 10-15 times to circulate the hydraulic fluid and expel air.
3. Vrid utlösningsventilen medurs för att stänga den.
4. Test the jack by raising and lowering it a few times without a load. If operation is not smooth, repeat the bleeding procedure.

Bruksanvisning

Lifting a Vehicle

1. Parkera fordonet på en hård, plan yta. Dra i parkeringsbromsen och blockera hjulen som kommer att stanna kvar på marken.
2. Locate the manufacturer-recommended lifting points on the vehicle chassis. Consult your vehicle's owner's manual.
3. Position the jack so the saddle is directly under the lifting point. Ensure the jack is stable and not on an angle.
4. Close the release valve by turning the handle clockwise until it is firm.
5. Pump the jack handle to raise the vehicle to the desired height. Lift only high enough to place jack stands.
6. Immediately place appropriately rated jack stands under the vehicle's designated support points.
7. Slowly open the release valve to lower the vehicle onto the jack stands. Ensure the vehicle is securely resting on the stands before proceeding with any work.

Sänka ett fordon

1. Ensure the area around the vehicle is clear.
2. Raise the vehicle slightly off the jack stands using the jack.
3. Ta bort pallbockarna under fordonet.
4. Vrid långsamt utlösningsventilen moturs för att gradvis sänka fordonet till marken. Öppna inte ventilen för snabbt, eftersom det kan orsaka att fordonet sänks snabbt.
5. När fordonet är helt sänkt, ta bort domkraften.

Underhåll

Regular maintenance ensures the longevity and safe operation of your AFF Service Jack.

Allmän vård

• Keep the jack clean and free of dirt, grease, and debris. Wipe down external surfaces after each use.
• Store the jack in a dry, protected area when not in use.
• Do not expose the jack to extreme temperatures or corrosive environments.

Hydraulic Fluid Check/Refill

Check the hydraulic fluid level periodically. Use only high-quality hydraulic jack oil.

1. Lower the jack completely.
2. Locate and remove the oil filler plug.
3. The fluid level should be just below the filler hole. If low, add hydraulic jack oil until the correct level is reached.
4. Sätt tillbaka påfyllningspluggen ordentligt.

Smörjning

Lubricate all moving parts and pivot points with light machine oil periodically to ensure smooth operation.

Felsökning av vanliga problem

Specifikationer

Garanti och support

Begränsad garanti

AFF products are manufactured to high-quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official AFF webwebbplats. Spara ditt inköpskvitto som inköpsbevis för eventuella garantianspråk.

Kundsupport

If you have any questions regarding the operation, maintenance, or troubleshooting of your AFF 2 Ton Wrecker Service Jack, please contact AFF customer support. Contact information can typically be found on the product packaging or the official AFF webplats.