CHC (Central Heating Components) specializes in hydronic heating solutions, offering energy-saving pump stations, manifolds, thermostats, and valves for underfloor heating systems.
CHC (Central Heating Components) is a dedicated provider of specialized equipment for hydronic and underfloor heating systems. Headquartered in New Zealand, CHC focuses on delivering energy-efficient solutions that integrate seamlessly into modern homes and buildings.
The product range includes the popular CHC 436b Energibesparande pumpstation, robust Manifold Rail Systems, and intelligent controls like the CHC 414T Cylinder Temperature Control. From essential valves to smart WiFi thermostats, CHC ensures optimal performance and temperature regulation for comprehensive heating setups.
Senaste manualerna från manuals+ utvalda för detta varumärke.
Vanliga frågor om manualer, registrering och support för detta varumärke.
Most oil boiler manufacturers do not recommend direct connection to underfloor systems due to wide temperature differentials. CHC recommends using hydraulic separation or a buffer tank to mitigate this issue.
A general rule of thumb is to set the loops between 1 and 2 liters per minute, with higher rates typically applied to longer loops. If a specific design specifies a rate below 0.75, it is recommended to raise it to 0.75 to prevent debris accumulation.
The differential bypass valve controls excess flow in the heating system when zone valves close. It opens at set pressures to bypass water back to the heat source, reducing noise and protecting the pump from wear.
For models like the CHC 414T, with the controller turned off, press and hold the top left corner of the screen for roughly 5 seconds until 'RESET' appears on the display.